Secondhand Maquet Hanaulux Wall Mounted Operating Light

Objective AI Report

Disclaimer: I am Medbidding AI. I am an unbiased AI robot. I have generated the following report automatically (without human intervention). The report was prepared by examining only the product images in the ad in detail. The report may contain errors. Medbidding and other parties disclaim any liability that may arise from this report or reliance on its contents. If you have any questions or notice an error in the report, please contact Medbidding engineers.

Report date: 02.08.2025

Medical Examination Lamp Analysis Report

Device Identification and Areas of Use

The product shown in the images is an examination lamp used to provide illumination during examinations and minor procedures in medical or dental fields. The product’s flexible arms allow the light source to be focused on the desired area. It is generally used in areas such as doctors’ offices, clinics, dentistry, and veterinary medicine.

Quantity Information

There is 1 unit of a medical examination lamp in the images. The lamp consists of the head and flexible arm sections.

General Status and Condition

The general condition of the device is assessed as new or very lightly used. No wear, dirt, or significant signs of use were observed on it. The lamp’s reflector part and outer casing are clean and shiny. It is understood that the product is disassembled and ready for assembly.

Physical and Mechanical Assessment

The inspections of the product’s physical and mechanical components are listed below:

• Casing and Body: No scratches, dents, cracks, or discoloration have been detected on the lamp’s white-colored body and flexible arms.
• Lamp Head: The lamp head, which has a light blue frame, is clean. The light-reflecting reflector surface is shiny and undamaged.
• Mechanical Components: The flexible and articulated arms used to adjust the device’s position appear to be solid. No looseness or damage has been observed at the joint points.

Electronic Components

There are two control buttons on the lamp head, believed to be one for on/off and one for illumination adjustment. On the main connection part of the device, which is to be mounted on the wall or a unit, the electronic circuit board is seen to be exposed without a protective cover. This situation may reflect a pre-assembly state.

Label and Code Information

The text on the labels on the device is not legible due to the resolution of the images. For this reason, information such as the serial number, lot number, or REF code could not be accessed.

Potential Risk Assessment

The fact that the electronic circuit board in the assembly section of the device is exposed can be considered a potential risk factor. Covering this section with a cap after assembly is important for protecting the circuit from external factors such as dust, moisture, and physical contact. Apart from this, no potential risk of malfunction based on wear or damage has been observed in the device. The product is generally in very good condition.