Objective AI Report
Disclaimer: I am Medbidding AI. I am an unbiased AI robot. I have generated the following report automatically (without human intervention). The report was prepared by examining only the product images in the ad in detail. The report may contain errors. Medbidding and other parties disclaim any liability that may arise from this report or reliance on its contents. If you have any questions or notice an error in the report, please contact Medbidding engineers.
Report date: 02.04.2026
Report code: 1775129089
80-2A Model Centrifuge Device Analysis Report
Device Identification and Areas of Use
The product shown in the images is a desktop centrifuge device used in laboratory environments to separate liquid samples by centrifugal force. As indicated by the rotor located inside the device, it has the capacity to process 12 sample tubes simultaneously.
Brand and Model
On the front panel of the device, the model number 80-2A is clearly legible in black letters. A blue label, subsequently affixed to the left front surface of the device, bears the inscription ATA; however, it cannot be definitively confirmed from the image whether this inscription refers to the manufacturer’s brand or a calibration/service company. Therefore, the device has been reported directly as the 80-2A model.
Quantity Information
- 1 desktop centrifuge device main body
- 1 fixed-angle rotor with 12 slots (mounted inside the device)
General Condition and Physical Deformation
The device is in used condition. The lower part of the body is light gray/cream colored, while the upper lid is dark gray plastic. The outer surface of the upper lid shows a significant amount of superficial scratches, scuff marks, and dullness. Although there are minor dirt and stains on the lower body, no breaks, cracks, or dents have been detected on the device’s casing.
Mechanical Components
The rear hinges holding the device’s upper lid and the front locking mechanism appear visually complete and sturdy. The black rubber seal ensuring airtightness is in place on the inside of the lid. The fastening nut at the center of the metal rotor in the inner chamber is attached. The two rotary potentiometer knobs on the front panel, which control speed and time settings, appear physically sound.
Electronic Components and Screen Analysis
Electronic control units are located on the front panel of the device. In the lower left corner, there is a power switch (ON/OFF) with a transparent plastic cover, and immediately above it, a red power indicator LED. In the middle section, a 4-digit red LED display is present. In one of the images, the display shows the inscription 8.8.8.8. with all segments lit, while in another image, numbers such as 5068 (or similar) indicating the device’s operating speed or status are visible. The fact that the screen and LEDs are lit indicates that the device is receiving power.
Capacity and Compatibility
The rotor inside the device bears the inscription 20ml x 12. This information indicates that the device is compatible with 12 tubes, each with a maximum volume of 20 milliliters. The tube slots on the rotor are numbered from 1 to 12.
Label Information
The blue label located on the front left side of the device displays the following information:
- Company/Institution: ATA
- Code: M1405018
- C.D.: 05-2014 (Probable Calibration Date)
- R.C.D.: 05-2015 (Probable Recommended Calibration Date)
Potential Malfunction Risk
No mechanical damage, rust, missing parts, or electronic error codes that would prevent the device from operating have been observed in the images. The extensive scratches visible on the upper lid are purely cosmetic and do not pose a risk to the device’s functionality. The overall condition of the device is good, apart from superficial wear and tear due to use.
