Objective AI Report
Disclaimer: I am Medbidding AI. I am an unbiased AI robot. I have generated the following report automatically (without human intervention). The report was prepared by examining only the product images in the ad in detail. The report may contain errors. Medbidding and other parties disclaim any liability that may arise from this report or reliance on its contents. If you have any questions or notice an error in the report, please contact Medbidding engineers.
Report date: 28.03.2026
Report code: 1774683708
Elektro-mag M 420 BP Incubator Analysis Report
Device Identification and Basic Information
The product in the images is an incubator device used in laboratory environments. Upon examining the device’s front control panel and the logos and inscriptions located in the upper right corner, its brand has been definitively identified as Elektro-mag and its model as M 420 BP. The inscription “INCUBATOR” indicating the device type is clearly legible on the control panel. There is 1 main device in the images. The industrial prints, logo placements, and panel design on the device indicate that the product is original.
Physical Condition
The device is in used condition. The outer casing is made of white/light gray colored metal. On the device’s front cover, along the edges of the control panel, and on the upper parts of the casing, there are superficial scratches, minor scuff marks, and tiny paint deformations. A yellow, rectangular plastic piece is located exactly in the middle of the device’s top panel. There are no structural dents or heavy impact marks on the casing.
Inner Chamber and Mechanical Components
The device has a double-door design. On the outside, there is an insulated main metal door, and on the inside, a black-framed transparent glass door for observing samples. The outer door has a gray plastic opening latch. The black locking latch and hinges of the inner glass door appear sturdy. The inner chamber has a metallic (stainless steel or aluminum) surface and is generally clean. There are a total of four metal shelf runners, two on each of the right and left walls of the inner chamber.
Control Panel and Electronic Components
A vertically positioned control panel is located on the left side of the device. It is understood from the digital display that the device is connected to power and operational. The details on the control panel are as follows:
- Digital Display: It is active. The images show a red “C” inscription and green digital numbers (8888 and 88.0).
- Membrane Buttons: Immediately below the screen, there are four yellow, elliptical buttons. These buttons are labeled “Select mode”, “SET DOWN”, “SET UP”, and “Off” respectively.
- Technical Inscription: Below the button array, the inscription “Microprocessor controller with KTY type temperature sensor” is legible.
- Safety Thermostat: On the panel, there is an analog rotary “Safety thermostat” knob, adjustable within the range of 0 to 90 °C.
- Power and Fuse: At the bottom of the panel, there is a black fuse (FUSE) slot and a green, illuminated ON/OFF power switch.
Areas of Use
Incubators are used in medical, biology, and microbiology laboratories for the purpose of producing, developing, and preserving cell cultures, microorganisms, and various biological samples under a specific and constant temperature.
Missing Parts and Accessories
The trays or shelves that should be placed on the shelf runners inside the device’s inner chamber are not present in the images. Apart from the power cable that enables the device to operate, no other external accessories, connection cables, user manual, or original box are visible.
Potential Malfunction Risk
No broken parts, heavy rust, severed cables, or error codes on the screen that would impede the device’s electronic or mechanical functions have been observed in the images. The device’s overall condition is good, and its basic functions are understood to be active from the operation of the digital display.
