Objective AI Report
Disclaimer: I am Medbidding AI. I am an unbiased AI robot. I have generated the following report automatically (without human intervention). The report was prepared by examining only the product images in the ad in detail. The report may contain errors. Medbidding and other parties disclaim any liability that may arise from this report or reliance on its contents. If you have any questions or notice an error in the report, please contact Medbidding engineers.
Report date: 25.10.2025
USA Instruments Extremity Large MR Coil Analysis Report
Overview and Product Description
The images show a device accessory understood to be used in medical imaging systems. This product, referred to as “Extremity Large”, is most likely a coil unit used for scanning limbs such as arms and legs in Magnetic Resonance (MR) imaging systems. The device consists of a main body and a pink foam support used to immobilize the patient’s limb. A total of 1 unit of the coil is visible in the images.
Brand and Model Information
According to the information on the label located on the product, the device was manufactured by USA Instruments, Inc. and distributed by Siemens. The device’s type or model is stated as “Extremity Large” on its casing and label.
Physical Condition and Deformation Analysis
The overall condition of the device is assessed as used. Slight discoloration/yellowing, dirt, and superficial scratches are observed on the outer plastic casing, consistent with its age and use. However, no cracks, fissures, or serious deformations that would compromise its structural integrity were detected on the casing. The blue lock or release latch on the upper part appears physically intact. The pink foam support inside is in a functional state and does not show any significant tears or detachments.
Technical Details and Label Information
The label on the bottom surface of the device provides important information about the product’s identity and technical specifications. According to the information on the label, the device was manufactured in April 2005. The codes and numbers on the label are listed below:
- Manufacturer: USA Instruments, Inc.
- Distributor: Siemens
- Manufacturing Date (MANUF): 04.2005
- USAI Part Number (P/N): 100201
- USAI Serial Number (S/N): 710
- USAI Revision (REV.): 2
- Siemens Part Number (P/N): 70 38 598 K2135
- Siemens Serial Number (S/N): 1410L
Additionally, the CE 0197 mark and other technical symbols are present on the label.
Connector and Electronic Components
A multi-pin connector, which provides the device’s connection to the main imaging system, is clearly visible in one of the images. The connector is housed within a protected receptacle against external factors. No signs of bending, breakage, or corrosion are observed on the pins. The overall condition of the connector appears good and ready for use.
Potential Risk Assessment
Based on visual inspections, no obvious malfunctions or broken parts were detected in the device’s structure. The discoloration and minor scratches on the plastic casing are purely cosmetic and are not expected to affect the device’s functionality. While the manufacturing year of 2005 suggests the device might be technologically old, it can be said to be in a physically well-preserved condition. The robust structure of the connector indicates a low risk of electrical contact issues.
