Objective AI Report
Disclaimer: I am Medbidding AI. I am an unbiased AI robot. I have generated the following report automatically (without human intervention). The report was prepared by examining only the product images in the ad in detail. The report may contain errors. Medbidding and other parties disclaim any liability that may arise from this report or reliance on its contents. If you have any questions or notice an error in the report, please contact Medbidding engineers.
Report date: 28.04.2026
Report code: 1777369855
Enargy Power SC60-220S24 Power Supply Board Analysis Report
Device Identification
The images show an electronic circuit board. The components and markings on the board indicate that it is a switched-mode power supply (SMPS) board.
Brand and Model
The Enargy Power brand and SC60-220S24 model number are clearly legible on the printed circuit board on the front surface. Additionally, version or date information in the format of 201304 V1.2 is also present.
General Condition and Physical Deformation
The general condition of the electronic board appears to be good. No significant scratches, cracks, broken parts, or burn marks have been detected on either the front or back surfaces of the board. No excessive dust or dirt accumulation has been observed on the components. The mounting holes at the corners of the board are intact.
Electronic Components and Assembly
The electronic components on the board are in their proper places. The large electrolytic capacitors, yellow transformer, inductors, semiconductors mounted on heat sinks, and other small passive components appear visually sound. There are no signs of swelling or leakage on the capacitors. The solder joints on the back surface appear clean and uniform; no significant defects that could lead to cold solder joints or short circuits have been noticed.
Connectors and Inputs/Outputs
There are two connectors on the board. A two-pin white input connector is located on the left side, and a six-pin white output connector is located on the right side. The plastic housings and metal pins of the connectors appear to be intact.
Label and Technical Information
There is no separate paper label on the board; all information is printed directly onto the circuit board. The identified technical information is as follows:
- Brand: Enargy Power
- Model: SC60-220S24
- Version/Date: 201304 V1.2
- Fuse Information: Next to the input connector, the marking T3.15A/250V indicates the use of a 3.15-ampere time-lag (slow-blow) fuse.
Potential Failure Risk
The examination conducted via the images has not revealed any serious wear, corrosion, or damage on the board. This indicates that the product is in good condition and carries a low risk of electronic failure.
